Two ways to estimate carpet
The quick way takes the floor area and adds about 10% for waste. It's fine for a budget, but it can be wrong either way, because carpet comes off a roll of fixed width.
The roll-cut way lays out real pieces. Each room is covered with strips ("drops") the width of the roll, cut a little long so they can be trimmed to the walls. The Carpet and Rug Institute's installation standard (CRI 105) calls for at least 3 in of extra at each wall for trimming.
Roll-cut: drops = room width ÷ roll width, rounded up
Cut length = room length + 6 in (3 in at each end)
Square yards bought = drops × cut length × roll width ÷ 9
Seams = drops − 1
The calculator tries the roll both ways across each room and uses the way that needs less carpet, then adds the rooms together.
Worked example
A 15 × 12 ft room has 180 sq ft, or 180 ÷ 9 = 20 sq yd. The quick estimate with 10% waste is 22 sq yd. With a 12 ft roll, one drop covers the 12 ft width, cut 15.5 ft long: 15.5 × 12 = 186 sq ft = 20.67 sq yd, with no seam. At $30 per sq yd that's $620.00 of carpet, and pad for 20 sq yd at $5 is $100.00.
A 15 × 13 ft room is wider than the roll. Laid across the 15 ft way it needs 2 drops of 13.5 ft: 2 × 13.5 × 12 = 324 sq ft = 36 sq yd with one seam, for a room of only 21.7 sq yd. A 15 ft roll covers it in one 13.5 ft drop: 22.5 sq yd and no seam.
Why the 10% rule can mislead
Waste depends on how the room's width compares with the roll. A room just over 12 ft wide wastes almost a whole extra drop, far more than 10%; a room exactly 12 ft wide wastes very little. Leftover pieces can sometimes fill closets or a second room, which is why installers draw a seaming diagram for the whole job.
Getting a realistic number
- Seams: CRI 105 says to keep seams to a minimum, run them the length of the room where possible, and keep them out of doorways and main traffic lanes.
- Pile direction: all pieces must run the same direction, so you can't turn a scrap sideways to fill a gap.
- Patterns need extra material to match; ask your dealer.
- Stairs, closets and doorways add material. Let the installer measure before you order.