How tire size is calculated
A metric (P-metric, LT or Euro) size like 265/70R17 has three numbers. 265 is the section width in millimeters. 70 is the aspect ratio: the sidewall is 70% as tall as the tire is wide. 17 is the wheel (rim) diameter in inches. The R means radial construction.
Overall diameter (in) = rim + 2 × sidewall ÷ 25.4
Circumference = π × diameter · Revolutions per mile = 63,360 ÷ circumference
A flotation size like 33x12.50R20 is already in inches: 33 in tall, 12.50 in wide, for a 20 in wheel. The sidewall is (33 − 20) ÷ 2 = 6.5 in.
Ground clearance change = (new diameter − old diameter) ÷ 2
Worked example
265/70R17: the sidewall is 265 × 70 ÷ 100 = 185.5 mm, or 185.5 ÷ 25.4 = 7.30 in. The diameter is 17 + 2 × 7.30 = 31.61 in. The circumference is π × 31.61 = 99.29 in, so it turns 63,360 ÷ 99.29 = 638 times a mile.
Going to 285/70R17: the sidewall is 199.5 mm (7.85 in) and the diameter 32.71 in. That's 1.10 in, or 3.49%, taller. The axle sits 1.10 ÷ 2 = 0.55 in higher. When the speedometer reads 60 mph you're really doing 60 × 32.71 ÷ 31.61 = 62.1 mph.
The 3% rule of thumb
Tire shops commonly advise keeping a replacement tire within about 3% of the original overall diameter. Les Schwab gives this rule, for example. Bigger changes make the speedometer and odometer read noticeably wrong, change the gearing and ground clearance, and a taller or wider tire may rub. The calculator flags any change over 3%. It's a rule of thumb, not a guarantee of fit. Width, offset, load index and speed rating matter too.
Getting a realistic number
- These are the design sizes on paper. A real tire's measured diameter varies a little by brand and model, and it grows slightly as it's inflated and shrinks as the tread wears.
- Under load the tire flattens where it meets the road, so it turns somewhat more times per mile than the paper figure. Manufacturers' spec sheets list the measured revolutions per mile for each tire.
- Speedometers aren't perfectly accurate even with stock tires. Check against a GPS speed reading after a size change.
- Always use a load index and speed rating at least as high as the vehicle placard calls for, and check the fit with your tire shop.
- If you switch between P-metric and LT tires, the load index isn't directly comparable — a P-metric tire used on a light truck or SUV is derated (its load capacity divided by 1.1). Have a tire shop confirm the load capacity at your inflation pressure. Toyo's technical bulletin gives the example of a P245/75R16 109S: 2,271 lb ÷ 1.10 ≈ 2,065 lb on a light truck.
- Older sizes with no aspect ratio, like 195R15, aren't supported, because the size alone doesn't give the sidewall height. Use the tire maker's published diameter instead.
Common tire sizes
Overall diameter, sidewall height and revolutions per mile for popular car, SUV and truck sizes, worked out with the formulas above.
| Size | Width | Sidewall | Diameter | Circumference | Revs per mile |
|---|---|---|---|---|---|
| 195/65R15 | 7.7 in | 4.99 in | 24.98 in | 78.5 in | 807 |
| 205/55R16 | 8.1 in | 4.44 in | 24.88 in | 78.2 in | 811 |
| 215/55R17 | 8.5 in | 4.66 in | 26.31 in | 82.7 in | 767 |
| 215/60R16 | 8.5 in | 5.08 in | 26.16 in | 82.2 in | 771 |
| 225/45R17 | 8.9 in | 3.99 in | 24.97 in | 78.5 in | 808 |
| 225/65R17 | 8.9 in | 5.76 in | 28.52 in | 89.6 in | 707 |
| 235/45R18 | 9.3 in | 4.16 in | 26.33 in | 82.7 in | 766 |
| 235/65R17 | 9.3 in | 6.01 in | 29.03 in | 91.2 in | 695 |
| 235/75R15 | 9.3 in | 6.94 in | 28.88 in | 90.7 in | 698 |
| 245/40R18 | 9.6 in | 3.86 in | 25.72 in | 80.8 in | 784 |
| 245/45R19 | 9.6 in | 4.34 in | 27.68 in | 87.0 in | 729 |
| 245/70R17 | 9.6 in | 6.75 in | 30.50 in | 95.8 in | 661 |
| 245/75R16 | 9.6 in | 7.23 in | 30.47 in | 95.7 in | 662 |
| 255/55R18 | 10.0 in | 5.52 in | 29.04 in | 91.2 in | 694 |
| 255/70R18 | 10.0 in | 7.03 in | 32.06 in | 100.7 in | 629 |
| 265/60R18 | 10.4 in | 6.26 in | 30.52 in | 95.9 in | 661 |
| 265/65R17 | 10.4 in | 6.78 in | 30.56 in | 96.0 in | 660 |
| 265/70R16 | 10.4 in | 7.30 in | 30.61 in | 96.2 in | 659 |
| 265/70R17 | 10.4 in | 7.30 in | 31.61 in | 99.3 in | 638 |
| 265/75R16 | 10.4 in | 7.82 in | 31.65 in | 99.4 in | 637 |
| 275/55R20 | 10.8 in | 5.95 in | 31.91 in | 100.2 in | 632 |
| 275/60R20 | 10.8 in | 6.50 in | 32.99 in | 103.6 in | 611 |
| 275/65R18 | 10.8 in | 7.04 in | 32.07 in | 100.8 in | 629 |
| 275/65R20 | 10.8 in | 7.04 in | 34.07 in | 107.0 in | 592 |
| 275/70R18 | 10.8 in | 7.58 in | 33.16 in | 104.2 in | 608 |
| 285/45R22 | 11.2 in | 5.05 in | 32.10 in | 100.8 in | 628 |
| 285/65R18 | 11.2 in | 7.29 in | 32.59 in | 102.4 in | 619 |
| 285/70R17 | 11.2 in | 7.85 in | 32.71 in | 102.8 in | 617 |
| 285/75R16 | 11.2 in | 8.42 in | 32.83 in | 103.1 in | 614 |
| 285/75R17 | 11.2 in | 8.42 in | 33.83 in | 106.3 in | 596 |
| 295/70R18 | 11.6 in | 8.13 in | 34.26 in | 107.6 in | 589 |
| 315/70R17 | 12.4 in | 8.68 in | 34.36 in | 108.0 in | 587 |
| 305/55R20 | 12.0 in | 6.60 in | 33.21 in | 104.3 in | 607 |
| 315/75R16 | 12.4 in | 9.30 in | 34.60 in | 108.7 in | 583 |
| 33x12.50R15 | 12.5 in | 9.00 in | 33.00 in | 103.7 in | 611 |
| 33x12.50R17 | 12.5 in | 8.00 in | 33.00 in | 103.7 in | 611 |
| 33x12.50R20 | 12.5 in | 6.50 in | 33.00 in | 103.7 in | 611 |
| 35x12.50R17 | 12.5 in | 9.00 in | 35.00 in | 110.0 in | 576 |
| 35x12.50R20 | 12.5 in | 7.50 in | 35.00 in | 110.0 in | 576 |
| 37x12.50R17 | 12.5 in | 10.00 in | 37.00 in | 116.2 in | 545 |
Sources
- Tire Industry Association: Reading a tire sidewall
- Les Schwab: What size tires should you get? (the 3% guideline, December 20, 2022)
- Tire Rack: What are plus size wheels and tires?
- Toyo Tires technical bulletin TSD-12-011: Replacing tires on light trucks (P-metric load reduced by a factor of 1.10, FMVSS 571.120), August 2012