Time how long a bucket takes to fill to get your flow rate in GPM, or work out the flow from a pipe's size and the water's speed.
The bucket test
The simplest way to measure flow is to time how long it takes to fill a container of known size. California's State Water Resources Control Board describes it: fill a bucket, time it, do at least three tries and average them, then divide the volume by the average time.
GPM = bucket gallons ÷ average seconds × 60
Pipe flow: GPM = 2.448 × velocity (ft/s) × inside diameter (in)²
The pipe formula comes from flow = velocity × area: π ÷ 4 × (d ÷ 12)² sq ft × v ft/s × 60 s × 7.48052 gal per cu ft = 2.448 × v × d².
Worked examples
Bucket: a 5 gallon bucket fills in 40 seconds. 5 ÷ 40 × 60 = 7.5 GPM. If three tries take 40, 42 and 38 seconds, the average is 40 seconds, so the answer is the same.
Pipe: 1 in Schedule 40 pipe (1.049 in inside) with water moving at 5 ft/s: 2.448 × 5 × 1.049² = 13.5 GPM.
Uses and tips
- Sizing equipment: water softeners, filters, irrigation zones and tankless water heaters are rated in GPM.
- Wells: a bucket test at an outdoor spigot shows the flow at that point; a pressure tank can make the first few seconds faster than the pump can sustain, so keep running it until the pump cycles on.
- Measure the bucket. A "5 gallon" bucket often holds a bit more when filled to the brim; mark a known level.
- Velocity: plumbing designs often keep water velocity at a few feet per second to limit noise and wear; your designer or code sets the limit.
Sources
How we checked this
Before every update, this calculator is run in a real browser with these known answers, and it must match all of them:
- 5 gallons in 40 s: 7.5 GPM ✓
- Three tries 40, 42, 38 s average 40 s: 7.5 GPM ✓
- 1.049 in pipe at 5 ft/s: 13.47 GPM ✓
- Edge: a fill time of 0 asks for a time ✓
Last checked October 26, 2026. Spotted something wrong? The math is done in your browser with the formula shown on this page, so you can check any result by hand.
Questions people ask
How do I calculate gallons per minute?
Time how long it takes to fill a bucket of known size, divide the gallons by the seconds, and multiply by 60. 5 gallons in 40 seconds is 7.5 GPM.
How many seconds should a 5 gallon bucket take to fill at 10 GPM?
5 ÷ 10 × 60 = 30 seconds.
What is a good GPM for a house?
It depends on the fixtures running at once. Add up the fixtures that run at once; for example, federal rules limit new showerheads to 2.5 GPM. A plumber can measure the flow at the main.
How many GPM through a 1 inch pipe?
At 5 ft/s, about 13.5 GPM for 1 in Schedule 40 (1.049 in inside). Higher velocity carries more but adds noise and friction.
How do I convert GPM to gallons per hour?
Multiply by 60. 7.5 GPM is 450 gallons per hour.